Woodworking Panel Clamps | Woodworking Ideas


Shop-made Horizontal Mortiser Downloadable Plan WOOD Magazine

4-Way Panel Clamps: Accurately glueing up large panels can be a real challenge. As you increase the clamping pressure, the panels have a tendency to slide out of vertical alignment or even worse buckle. 4-way panel clamps are the answer to both problems but commercia

DCT 4-Way Pressure Release Clamp - Wood Panel Corner Clamping System Woodworking Bracket Set - For Stock up to 6 Inches. 4.7 out of 5 stars 3. $30.23 $ 30. 23. Get it as soon as Tue, Oct 8. FREE Shipping by Amazon. Jorgensen Cabinet Master 24-inch 90┬░ Parallel Jaw Bar Clamp, 2-Pack.

The small steel clamping head can easily dent the edge of a panel under pressure, regardless of whether you're clamping hard or soft wood. You can deal with this in two ways, either by making your panels over wide, and sawing or planing off the dented edge after glue-up, or, better yet, you can use a caul, which will also help spread out the clamping pressure.

Align the center of the workpieces being clamped with the center of the clamping force, in this case, the screw on the pipe clamps. This places your glue joint directly in line with the clamp's greatest pressure. Use scrap stock to elevate the assembly to the screw height.

The WoodRiver clamping system applies equal pressure from all four directions. Ideal for gluing table tops, shelving, veneer, and laminates. Attach clamps to any length 2 x 2's with screws provided, set jig and turn handle to tighten. It can be used on boards up to 6" thick. Clamp has plastic pressure pads and two 19

The #180A-M2 pneumatic panel flattener works by sliding over the top of the wood and underneath and across two of the clamps. When you actuate the pneumatic valve, the long steel tube clamps down on the top of the work piece, while the cross tube presses up on the bottom of the clamps on either side.